Quick-install tensioner module, allowing the tension of the belts to be relocated to the rear part of the machine, thus freeing up the print head. Makes the future head compatible VZBOT On the Vcore3, the future Flathead 3.0 as well as the other head mods without a tendon

Compatible with any VCORE 3.0/3.1 200/300/400/500, any Enclose (1.0/2.0) Compatible with BRS-AWD Drive

ATTENTION PRINTED PIECES WITH INSERES ONLY

Its installation is done in 30 minutes and limits the dismantling of the machine.

Its major advantage compared to existing solutions is that it does not use the motors as tension elements. This reinforces the reliability of the XY motor blocks, the axes and allows a very precise tension at +-0.05mm.

The block sits at the back of the machine between the two extrusions at any level.

After adjustment the system locks with the two shoulder screws to fully secure the assembly

Allows 16mm adjustment travel

CAD STEP Inclus